There is nothing better than knowing how to maintain a treasurable item. Your Berkey pro care maintenance kit is one of the items that need to be taken care of properly. Many people have wondered if they can use vinegar in cleaning Berkey water filters. Well, Some instructions will guide you to achieve your goal. You can buy a maintenance kit from USA berkey filters.
Let’s see how you can use vinegar in cleaning Berkey filters.
How you can use Vinegar In Cleaning Berkey Filter
Acetic acid is what is used in making vinegar. The acid works best at dissolving organic matters like soap scum or any other contaminants. Hence, you can use vinegar in cleaning Berkey filters. The below are the ways you can successfully use vinegar as a means for cleaning your Berkey filtration system-;
- Get a large clean bowl and pour into it two cups of white distilled vinegar. Add 4quarts warm water into the bowl and stir.
- Inside the bowl with the vinegar solution, place the lid upside down after removing it from the Berkey filter.
- Next, you will have to soak the Berkey overnight.
- Then, thoroughly rinse it with clean, freshwater.
- Next, the lid should be placed into the Berkey filter and left to completely dry.
- Then, after 24hours, you should test the water quality.
- Every few months, You should repeat steps 3-6. However, it depends on how you are using the Berkey filter.
- The cap should be changed once a year to prevent mold growth.
- Baking soda should be used as an alternative to boiling water.
- Old table salt that is plain and it is mixed with water should be used. You should use a small quantity of water and a small quantity of salt. If you are to use much, it can cause a lot of damage to the Berkey filter, which you wouldn’t like. Hence the quantity of salt that you should use will not pass 4% concentration.
If you want to make the solution, you will have to take ¼ teaspoon of salt and dissolve it in an 8ounce of water. Then stir properly till the entire salt dissolves. If the solution becomes lumpy, you can heat it, but it should be very light heating while heating it. Then, you will take the lid away from the Berkey filter pour the solution carefully through the holes in the bottom of the filter.
Please do not use force to bring the solution out through the openings but instead, during it slowly, you can tilt the filter.
When you are done, you can change the cap and hold in for a full day which is 24hours before attempting to wash the filter.
How To Properly Clean A Berkey Carbon Filter
You will need to have certain things if you want to clean up your Berkey Carbon Filter properly. It includes-:
- A bucket filled with water
- Vinegar or lemon
- Sponge
- Soft cloth
- Small bowl
- A spray bottle that has lots of warm water
Process-:
- Measure 1 cup of boiling water into the bucket
- To get clear and clean water, add some vinegar and stir, then leave for 10 minutes to make the acid dissolve well.
- Then soak the mixture.
- Then use the sponge to scrub off any deposits of the mineral.
- Under running hot water, use it for thorough rinsing.
- Repeat the process two times.
- Next, Rinse the whole filter in cold water. So that you will know if it is clean enough, the color will change from dark brown to light gray.
Soak the mixture as long as possible to see how much better it gets. Then use a soft sponge to scrub off the mineral deposits. Rinse thoroughly under running hot water. If necessary, repeat the process twice. Finally, rinse the entire filter with cold water. You should see the color change from dark brown to light gray.
CONCLUSION
So, do you still wonder if you can use vinegar to clean your Berkey filters? As discussed above, you have seen the ways to get your Berkey filter looking sparking and very clean inside out. Try the method and give us your feedback on the result. We hope you find this article helpful in getting your Berkey filter to be in the spotlight.